The Hi-Tuck "Rock Basher" Cat-Back Exhaust System is constructed of 2-1/2" mandrel-bent stainless steel tubing. The smooth curves and increased diameter of this exhaust system helps remove restriction and keeps exhaust gas flowing smoothly for increased horsepower, torque and throttle response. This exhaust system also comes complete with a 14" length high-flow straight through designed muffler to absorb high pitch tones producing a powerful sound. All necessary hardware is included for a hassle-free installation. This unit fits with most after market Evap skid plates.
Flow and Performance:
This MACH Force-Xp cat-back exhaust system is constructed of 2-1/2" mandrel-bent, 409 stainless steel tubing for maximum flow. The smooth transition bends allow for low turbulence, increasing horsepower, torque and improving throttle response.
Forward Muffler Location:
This system incorporates a high flow 14" length muffler for an aggressive sound. The muffler is located prior to the rear axle for increased climbing angles. This system may have a slight drone in some applications due to the short muffler.
This exhaust system is finished off with a Hi-Tuck Tip that is developed to give your Jeep extra clearance during extreme angle climbs or descents.
An included extension pipe allows this system to fit both the 2 and 4 door Wranglers without modification. OE-style bayonet hangers are used to maintain a stable pipe location during high vibration and high heat conditions. The Bayonet tip holds the hanger bushing in place for an OE style fit that does not change with time.
The 409 stainless steel performance muffler is designed to provide a deep, throaty, powerful sound on acceleration but maintain a smooth sound at idle.
Use with Air Compressor Kits:
The driver-side exit location is perfect for adding on-board air compressor system to the underside of your Jeep. If you are considering an on-board air compressor kit, you need to use this system. Compatible with aFe Power's Glide Guard (46-79001)
This item fits both 2-Door and 4-Door models
This product does not require a CARB EO#
All aFe exhaust systems are engineered and manufactured in our Corona, California facility.